Heavy Duty, Slide Gate Operator that uses two 1/2 horsepower motors working together to equal one horsepower. For use on heavy gates.

One Horsepower Slide Gate Operator that uses two 1/2 horsepower motors working together to equal one horsepower. For use on heavy gates The SL-3000-UL-1HP is our most powerful slide gate operator. This operator was designed with heavy gates in mind. It delivers 210 pounds of pulling torque and is capable of 35 cycles per hour on gates up to 2000 pounds and 37 feet in length. Equipped with two 1/2 horsepower motors that motors and a heavy duty transmission. It is the perfect choice for large and heavy wrought iron gates.

Electrical Specifications:

120 VAC Power:  built-in 120 VAC power receptacle (NEMA 5-15).
Alarm:  If the gate hits an object twice while opening or closing, the system will shut down and an alarm will sound for five minutes.
Burglar Alarm:  With Omni Option board, interfaces with existing home alarm or alarm output.
Digital Motor Protection:  Entrapment sensor shuts off the motor after it reaches the stall amp for 3 seconds, reverses direction for several inches and stops.
Electronic Inputs Radio:  receiver, key switch, safety loop, center loop, telephone entry system, computer input, fire department key switch, and 3-push-button station.
ERD Sensor:  If the gate hits a vehicle while closing it re-opens. If it hits a vehicle while opening it stops, reverses 4 to 6 inches and stops again.
Gate Traveling Time:  Adjusted by a precision mechanical device and electrical limit switch system.
Integrated Loop Detectors:  Easy to install, modular, plug in loop detector inputs for exit loop, center loop, and safety loop.
Intelligent Master/Second:  Precise, synchronized movement and communication between two gate operators using three wire RS-485 bi-directional technology.
Magnetic Lock:  With Omni Option board, magnetic lock system is incorporated, allowing easy addition of the MG1300 locking system to the gate.
Modular Board Uses:  LEDs to indicate all input and output functions of the gate operator.
Motor Drive Solid:  state electronic motor drive system is incorporated into the board.
Power Input:  Controls power input to the board with convenient switch.
Power Management:  Board includes electronic power management with over curent shutdown and automatic recovery.
Soft Stop:  Gate travels through the cycle at normal speed and comes to a stop slowly for more accurate gate cycle. Equipped with integrated time delay for long mechanical life expectancy.
Spike Suppressors:  20,000 Amps and near lightning protection with modular omni surge suppressor. Initial response time: 0.000000000001 seconds.
Three Push Button Control:  On board gate operator control for close, stop and open.
Timer:  Adjustable timer can be set from 0-60 seconds Approval UL and ETL listed to the latest UL325 and UL991 specifications.

Mechanical Specifications:

Approval:  UL and ETL listed to the latest UL325 and UL991 specifications
Chassis:  Constructed with .25 inch sanded, welded, and gold zinc plated sheet metal
Cover High density polyethylene plastic and stainless steel for excellent heat and corrosion resistance
Cycles:  35 cycles per hour with a 36 foot gate
Dimensions:  Length = 18in x Width = 19in x Height = 25in
Emergency Release:  The handcrank is standard. Best option is our DC-1000™
Finish:  All metal parts are gold zinc plated for rust proof protection
Gate Length:  37 feet maximum gate length
Motor:  Equipped with two 1/2 hp parking gate motors that work together equalling one horsepower
Output Shaft:  1 inch cold rolled steel
Travel Speed:  12 inches per second average gate speed
Weight:  139 pounds
Weight Capacity:  2000 pounds maximum gate weight
Worm Gear Reduction:  30-to-1 worm gear reduction in an oil bath